info@barrejtech.com +971 52 603 4813
Image
Image
About us

Depending on your needs.

Barrej Tech Sandblasting, Powder-coating, and recently added Steel Works facility is a young and motivated company under German ownership and management. With our high-tech equipment and quality materials, we take responsibility and passion in our work.

From fabrication/welding to sandblasting, powder coating, curing, up to packing of the finished products. We make sure that our customers will be fully satisfied.

Our premises are exceeding 5300 square feet located in Umm Al Quwain's new and developing Emirates Modern Industrial Area

07+

Years of

Experience

Our Location

Our premises are exceeding 5300 square feet located in Umm Al Quwain's new and developing Emirates Modern Industrial Area

our process.

Process One: Blasting

Blasting is the first step of the powder coating procedure. It means applying material (such as steel grit, garnet, etc.) on the surface with high pressure for removing all contaminations, dirt, and impurities. Blasting is by far the most efficient and environmentally friendly process of cleaning materials.

Process two: Anti-corrosion Coating

Anti-corrosion Coatings (Epoxy Primer) allow for added protection of metal surfaces and acts as a barrier to inhibit the contact between chemical compounds or corrosive materials. Epoxy Primer is recommended to all clients if products are not coated within 24 hours.

Process three: Powder Coating

Powder Coating nowadays is slowly replacing wet paint on most metals. It means spraying electrostatic deposition (ESD) on the surface of the metal. The powder is usually applied to the metal via a spray gun which electrostatically charges the powder to attract it to the grounded part.

Process Four: Baking

Baking in an oven at a temperature between 160 - 240° C. The heat causes a chemical reaction that produces long molecular chains which make the coating much more resistant against environmental disturbances. It goes without saying that the materials must be clean before starting the powder coating procedure.