info@barrejtech.com +971 52 603 4813
Service Image

Abrasive Blasting

First step of the powder-coating procedure. It means applying material (such as steel grit, garnet, etc.) on the surface with high pressure for removing all contamination, dirt, and impurities. It is by far the most efficient and environmental-friendly process of cleaning material.


Service Image

Corrosion Treatment

Protect metal components against degradation due to moisture, salt spray, oxidation, or exposure to a variety of environmental or industrial chemicals in a range of industries. Anti-corrosion coatings allow for added protection of metal surfaces and acts as a barrier to inhibit the contact between chemical compounds or corrosive materials.

Service Image

Steel Fabrication

Metal fabrication is a process that involves bending and cutting metal to form a specific, boilerplate structure or product. In comparison, custom metal fabrication involves cutting materials in a specific way to meet the needs of customers instead of attempting to maintain a standard look or size.


Service Image

Powder Coating

It is spraying an electrostatic deposition (ESD) on the surface of the treated metal. The powder is usually applied to the metal by a spray gun which electrostatically charges the powder to attract it to the grounded part. It is used more often than wet paint.

our process.

Process One: Blasting

Blasting is the first step of the powder coating procedure. It means applying material (such as steel grit, garnet, etc.) on the surface with high pressure for removing all contaminations, dirt, and impurities. Blasting is by far the most efficient and environmentally friendly process of cleaning materials.

Process two: Anti-corrosion Coating

Anti-corrosion Coatings (Epoxy Primer) allow for added protection of metal surfaces and acts as a barrier to inhibit the contact between chemical compounds or corrosive materials. Epoxy Primer is recommended to all clients if products are not coated within 24 hours.

Process three: Powder Coating

Powder Coating nowadays is slowly replacing wet paint on most metals. It means spraying electrostatic deposition (ESD) on the surface of the metal. The powder is usually applied to the metal via a spray gun which electrostatically charges the powder to attract it to the grounded part.

Process Four: Baking

Baking in an oven at a temperature between 160 - 240° C. The heat causes a chemical reaction that produces long molecular chains which make the coating much more resistant against environmental disturbances. It goes without saying that the materials must be clean before starting the powder coating procedure.